Skip to content
For the complete documentation index, see llms.txt. This page is also available as Markdown.

D24

Configure D24 card redirect payments with Hyperswitch.

D24 routes card payments through a hosted redirect. It supports payments in Chile only, in CLP and USD. The redirect completes with automatic capture and supports refunds. Mandates are not available for this payment route.

Status and capabilities

Integration status: beta

Category: payment gateway

Webhook flows: None declared in code

Payment method
Type
Mandates
Refunds
Capture methods
Countries
Currencies

card redirect

Card Redirect

not supported

supported

automatic

-

-

Authentication

Provide the API Key, Read-only API Key, and API Signature requested by the connector configuration. These labels map to the three accepted signature-key fields in D24AuthType::try_from() and are declared in the d24.connector_auth.SignatureKey configuration.

Before you start

For D24 account setup or enablement in Hyperswitch, reach out to the Hyperswitch team on Slack or through Juspay's contact form. D24 is not available in the Hyperswitch control center.

Webhooks

D24 webhooks are not currently supported. Use Hyperswitch's Unified Connector Service (UCS) to sync payment and refund status. D24's direct connector sync methods are not used. See IncomingWebhook for D24, the UCS routing configuration, and D24 refund routing.

Source reference

Authentication and webhook behavior on this page is tied to Hyperswitch d03f8547d6367fab56690e4f5043590be4935dcd. See D24 connector source and D24 transformers.

Last updated

Was this helpful?